Home > Engine Monitors > Small Diesel Engine Controller

Small Diesel Engine Controller

Key Features

  • Tested to SAE J1810 Vibration
  • RPM Input: Alternator, Mag Pick-up and Negative Side of
    Ignition Coil
  • Accomodates Most Temperatures and Pressure Senders
  • Plug and Play Installation
  • Provides Connection for Auxiliary Shut Down Switch Signals
    (Switch to Ground), Oil Level, Low Water and Others
  • Displays Data in Analogue and Digital
  • IP66 Front and IP67 Rear
  • One Button Start, Remote Start Capable

The Small Diesel Engine Controller provides seamless monitoring of engine's key parameters: coolant temperature, oil pressure, voltage, RPM, engine hours and alarms.

Additionally, the Controller shuts down the engine when triggered by low oil pressure, high temperature and engine over speed. The C3 Engine Controller is an ideal electronics controller for mechanically governed engine based applications.

With 7 analog inputs, 4 relay outputs combined with 3 digital inputs, 2 CAN input connections, plus a USB port the C3 allows maximum function.

The QVGA colour display can be viewed in full sunlight, the unit is totally sealed and electronically extremely durable. It
is equipped to meet the challenge of providing tough, flexible, maintenance free instrumentation in even the harshest of environments.

Hardware
CPU Freescale iMX 286 (454 MHz ARM926EJ-S)
FLASH Memory 128 MB NAND
SDRAM 128 MB
Electrical
Display a-Si TFT LCD 3.5'
Resolution 320 (H) x 240 (V) QVGA
Active Area 70.08mm (H) x 52.56mm (V)
Viewing Angle 130/110 degrees from 6 O'clock
Number Of Colours 64K
Contrast Ratio 300:1
Brightness 750 NIT (cd/m2)
Power Requirements 10V to 32V DC
Sounder Internal Buzzer
Connection

(1) 12 Pin Deutsch DT04-12PA Moulded in Receptacle Mates With Primary DT06-12SA

(1) 12 Pin Deutsch DT04-12PB Moulded in Receptacle Mates With Secondary DT06-12SB

Communications 1 X RS232, 2 X CAN Bus 2.0B (1 isolated), USB2.0
Inputs 7 x Analog, 3 x Digital
Outputs 4 x Relay
Environmental
Operating temperature -40°C to +70°C
Storage Temperature -40°C to +80°C
Degree of Protection IP67 Rear, IP66 Front
Mechanical
Case material ABS
Case colour Black
Dimensions 95mm (W) x 95mm (H) x 23mm forward and 23mm rear (D)
Part Number
C3 Engine Controller 70073

To download a technical datasheet please complete the fields below. You will not be added to a mailing list!

    Read how we plan to use the data that you submit.


    Contact Us

      Read how we plan to use the data that you submit.

      Fugro Survey PTE

      Fugro Offshore Surveys Division provides survey services to the offshore oil and gas industry with operating bases in Malaysia, Brunei, Indonesia, Thailand and Singapore.

      harnTRONICS

      harnTRONICS provides wiring harness assemblies, battery cables, and turn key solutions in the field of solutions to the automotive, off highway vehicle, and electronics industry; flexible to customer requirements and improving performance.

      Kongsberg Maritime

      Kongsberg Maritime delivers products and systems for dynamic positioning, navigation and automation to merchant vessels and offshore installations.

      The Metasystems Division of Kongsberg Maritime was searching for a programmable display that could be used to show specific sensor data that measured shaft power and torque.

      Specialist Instruments Ltd

      The M4 display is integral in providing a pumping operating system that delivers peace of mind and enables valuable capital equipment to be run unattended.

      DSE Test Solutions

      In this application The C3 is configured to accurately measure and display the moisture content present when baling and cope with a diversity of crops.