Home > Support > Mounting Templates

Product Mounting Templates

Our displays are designed to be mounted onto a bulkhead, dashboard, or panel. The method is described below, the only required components are the mounting bracket and hardware. Our installation manual can be downloaded by clicking the following:

Veethree Display Installation Manual

Instructions:

  • Allow adequate clearance behind the display for cable connection (to ensure that the cables are not unduly stressed), and for ventilation. Leave sufficient cable so that the unit may be removed for servicing.
  • Screw the threaded studs into the rear case.
  • Carefully cut out the mounting hole, templates are available upon request if required
  • Place the Display in position, use the mounting bracket and thumb nuts to secure the units. The thumb nuts should only be hand tight.
  • In the correct order attach the Deutsch mating connector harness into the housing, ensuring it is fully seated

WARNING:  Do not over tighten the studs/thumb nuts and don’t use metal screws as they may damage the unit and void the warranty.

M Series

M2 (CANvu 230)

Mounting template can be downloaded below.

canvu-230-mounting-template

M4 (CANvu 260/261)

Mounting template can be downloaded below.

canvu-260-mounting-template

C Series

C3 & C3i (CANvu 355 & 355 Lite)

Mounting template can be downloaded below.

CAN 355 Mounting Template

C3l & C3li (CANvu 355 Low Profile & Lite Low Profile)

Mounting template can be downloaded below.

C3l C3li Fitting Template

C7 (CANvu 700)

Mounting template can be downloaded below.

canvu-700-mounting-template

T Series

T5 (CANvu 500)

Mounting template can be downloaded below.

T5 Fitting Template

T7i

Mounting template can be downloaded below.

T7i Fitting Template